The Xbox 360 is an amazing package in itself. However, with games like Call of Duty 5, Modern Warfare, and Modern Warfare 2, more and more people find reasons to modify the said game console, or its accessories. One particular modification is just a response to produce a rapid fire modded Xbox 360 controller. Here will be the steps on the best way to modify your original controller to a rapid fire controller. https://bestxboxonecontrollers.com/powera-spectra-enhanced-illuminated-wired-controller-buyer-guide/
Step 1. Unscrewing the controller
Prior to starting taking your controller apart, have a close consider the controller first and try to remember which parts go where because you will eventually have to put everything back again. Start by unscrewing all the visible screws at the back. Following this, when you tug on the case, remove the batteries to reveal the hidden screws. Remove these as well.
Step 2. Preparing the Case
With the controller facing down, slowly and carefully separate leading half the casing from the circuit board. A gap in case will eventually must be made. Remember this before putting things back.
Step 3. Placing The Rapid Fire Button
While other methods of modifying the controller do not involve installation of a fresh button, this specific guide does. Not only does this ensure it is easier to adjust the rate of rapid fire, it minimizes tampering with other areas of the circuit board, thereby minimizing the chance of damaging your modded Xbox 360 controller.
Remember, kits for the rapid fire controller can be purchased easily. It's the button from this kit that will be placed through the hole in the casing, so stick it gently before the circuit board is returned. You might have to snip out a couple of flaps to create way for the wires of the kit. This can be done with whether cutter or a couple of scissors.
Step 4. Soldering
Assuming that you learn how to properly utilize a soldering iron, attach the red wire to the leftmost pin of a 4-pin horizontal series, whilst the blue wire solders to the rightmost pin of the same series. The black (or green in some cases) wire attaches to the midst of the three vertical series to the right of the switch.
Soldering is the absolute most crucial step to making the modded Xbox 360 controller. This is because mistakes made in this stage can permanently damage your controller.
Step 5. Putting everything back
Carefully taking note of the wires, try to close the circuit board and the casing. This might be only a little tricky because the new wires are certain to get in how of things. Discover a way for these wires to occupy the empty spaces rather than sticking out. You could support the modded Xbox 360 controller facedown so the buttons don't fall and maneuvering the wires really are a little easier. Put the casings together but don't return the screws yet.
At this point you need to check on if the rapid fire buttons work. If they do not, you may need to restart both your console and the now modded Xbox 360 controller. This will solve the problem. When it doesn't then you may need to feel the steps again to double check.
Comments
Post a Comment